Yes, Hold down the menu key to enter the config menu. Rotate VFO B knob until you find TUN PWR set this setting to your desired tune power. I hope this helps.
Mike N8XPQ Todd Ruby wrote: > > I have just put the K3 on the air for the first time after > downloading all firmware upgrades. When I hold TUNE pwr is at 0 and > rotating the PWR ctrl gets it to a desired output just fine. when i > go to retune it is back at 0 watts and I have to rotate the PWR knob > each time. What is the way to have the PWR be at least set to where > it was previously? > > tnx in advance > > > > > 73 > de > todd > WB2ZAB > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > ----- Mike Koetje N8XPQ -- View this message in context: http://www.nabble.com/tune-pwr-tp17152193p17152559.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
