G'morning Mike:
For the Transmitter Gain procedure on page 46 of the Owner's Manual, set
the power control to exactly 5.0 watts, press TUNE. Do NOT readjust the
power control. Just do each step of the procedure in the manual on all
bands.
73,
Ken K3IU
Mike Kasrich wrote:
I will number them since Im sure there will be more than one.
In the low power Tx calibration procedure. You go band to band and
set the power to 5w and push the various buttons in sequence.
Question........once you have xmit to the dummy load do you move the
power control so the reading is exactly 5w or do you leave the power
control alone since this is for calibration only? I note that the
power varies from band to band (5w on 160 to 3.5w on 6m) so if the
radio is supposed to know where the power level for 5w is then I need
to move the pot a bit each band.
Mike/aj9c
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
