Ron,
Does your K3 have the subreceiver installed? I do not think they have
shipped yet because they are waiting for the shields (they will go out
to the field testers quite soon). - so since you cannot have the
sub-receiver installed, to see an error for the sub-receiver VFO is
natural and to be expected.
73,
Don W3FPR
Ron Spencer wrote:
Trying to calibrate my newly finished K3. Downloaded newest firmware and can
calibrate the VCO for the primary VFO but fails the sub.
Also zero output on 6.
Firmware: 1.88
FPF .01
DSP1 1.70
DSP2 1.70
Can transmit and receive fine on main VFO (except of course for 6).
Any help would be appreciated.
Thanks
Ron
N4XD
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.23.14/1425 - Release Date: 5/9/2008
12:38 PM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.23.15/1426 - Release Date: 5/10/2008 11:12 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
