Steve,
I suggest that you read the entire Programmer's Reference paying
particular attention to the command syntax. There is more to it than
just entering the command itself. During that reading process, you
should then understand GET and SET. Try a few commands from a terminal
program first to get a feel for the syntax and command usage.
After that, review your logging application to see if it automatically
adds anything to that which you enter into the macro - if it does, that
will have to be taken into consideration.
73,
Don W3FPR
n4lq wrote:
That didn't help. I tried entering FWxxxx4 and nothing happens as if
nothing is being sent. There must be something that preceeds the
command. The manual keeps mentioning GET and SET....Are you supposed
to enter that somewhere?
Steve Ellington
[EMAIL PROTECTED]
----- Original Message ----- From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "n4lq" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Thursday, May 15, 2008 6:01 PM
Subject: Re: [Elecraft] K3 Serial Commands?
Steve,
Look at the "FW" commamd in the KIO2 Programmer's Reference.
73,
Don W3FPR
n4lq wrote:
I'm trying to configure Mixw macros so it will send commands to select
various filters, FL2 etc....
The "Programmer's Reference isn't much help to me. I was able to
interpet the commands for my IC-7800 easily but this has me stumped.
Can someone help me get started by telling me the command format for
one of the filters?
Steve Ellington
[EMAIL PROTECTED]
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.23.16/1434 - Release Date:
5/15/2008 7:24 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.23.16/1434 - Release Date: 5/15/2008 7:24 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
