I was setting up some band edge memories (KM5Q's post of 5/10). I goofed and hit M>V instead of V>M. Then selected an 'empty' memory position, the main freq display was "- - - -". I hit M>V again. The VFO jumps to 49.9940 mHz and displays ERR PL 1
Seems like the M>V routine should test for a valid frequency. Manual frequency entry or selecting a properly setup memory brings the K3 back all OK. I couldn't find reference to this - sorry if it's a dupe. Using the beta firmware 1.96 73, Bill N2BC K3/929 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
