I was working on my new K2 Alignment and Test Part III
All was going well until I got to the 40 Meter TX Alignment page 78
I followed the instructions but when I got to the "put K2 into TUNE
mode to peak the L1 I had not RF out. the display showed P.01 not the
P2.0
I was expected.
I tested and checked and could not find the problem. So I tried
another band.
This is what I found with the power out set to P 2.0
80M P 2.0
40M P .01
30M P 2.3
20M P .01
17M P 2.2
15M P 2.0
12M P .01
10M P .01
I have 4 bands with RF out and 4 band that do not.
I am missing the common connection in the 4 bad bands and what to
check next or what the problem could e.
I have check the obvious but I am missing something.
I have got through the reflector archives and have not found any
posting with this problem
Thanks in advance for any help
Larry
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
