Eric, Tnx for the info. I just measured R33 and R40 - 6.3 ohms. At this stage does it matter whether I leave the shorts in place or should I solder these two resistors back?
N2TK, Tony -----Original Message----- From: Eric Swartz - WA6HHQ, Elecraft [mailto:[EMAIL PROTECTED] Sent: Wednesday, May 28, 2008 1:18 PM To: N2TK Cc: 'Elecraft Reflector' Subject: Re: [Elecraft] K3 - HAGCMDKT mod kit Hi Tony, Nothing was required on your part. That is the factory version of the change that already has very low value SMD resistors installed for R33 and R40. 73, Eric WA6HHQ N2TK wrote: > Went to install the HAGCMDKT kit on #311. Interesting but all was already > done except for shorting R33 and R40. Maybe there were interim fixes for > this mod? > > By the way, C222 had already been changed to .1 uF for the CW Keying Rise > Time Reduction. I needed to add the RXA board to the KXV3. > > > N2TK, Tony > #311 > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
