I too like MixW for similar reasons. I imagine Nick Fedoseev would not require much persuasion to write support for the K3. That might be a better way forward.
73 Stephen G4SJP On 01/06/2008 12:17, "David Robertson" <[EMAIL PROTECTED]> wrote: > Elecrafters. > > I am fairly new in the K3 world and still in the learning phase but I noted > the following: > > When programming a memory one of the parameters that doesn't get stored is > what input you are using. > > Let me explain myself. > > I love using MIXW software on psk. Why? well when you log a qso in PSK mode, > the actual frequency that you are transmitting on in the PSK mode is logged > (Example: instead of 14.070 MHZ you would have 14.0715). > > MIXW does not have a K3 entry but it does have a K2 entry under Kenwood which > allows the K3's frequency, and mode to automatically entered into the > software. > MIXW then calculates the actual output frequency by adding the audio frequency > to the base 14.070. > > Because of the software's limitation to only the K2, I cannot select DATA mode > from that software. If I force the K3 into DATA mode then the frequencies are > all wrong. > > Because of the above I use the USB mode and select the LINE-IN input, cut the > CMP to 0 and adjust the computer output or mic gain for proper driving. > > I fully understand that the DATA-A mode only allows LINE-IN input to be > selected and automatically cuts compression, but I really do like having the > actual frequency in the log. > > I have had many very enjoyable qsos this way with very good reports and can > use the Width and Shift to filter out any unwanted qrm. > > So, Would it be possible to include the input selection in memory? > > Thanks > > 73 > Dave KD1NA > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
