Great idea, Peter. I've had the same problem with my K2. FYI, a
somewhat thinner (and less expensive) variety of this non-slip
material is also sold as shelf liner, to keep dishes, glasses, etc.
from sliding around on shelves in the kitchen cupboards.
73
--
Joe KB8AP
On Jun 2, 2008, at 7:08 AM, Peter G3MLO wrote:
I decided to revamp the operating position to install
the new K3, it sits on a shelf about 6" above the desk
top, I found, due to the light weight that when operating
the push buttons the rig was sliding around, a solution was
found by sitting it on a "grip mat" found over here in any DIY
store or tool supply outlet, its used for gripping timber when
using a router...... it now stays firm like it gained 100lbs in
weight.
73 Peter G3MLO.
--
View this message in context:
http://www.nabble.com/K3-Useful-tip-tp17602213p17602213.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
