Brian,
That antenna is commonly referred to as "two half waves in phase" and
has 2 to 3 dB gain broadside to the radiator.
Yes, its feed impedance is high, but if the feedline is somewhere near a
quarterwave (or odd multiple thereof) long at the frequency of interest,
the feedline impedance at the shack end will be low.
A bit of 'playing' with a program like TLW (download for ARRL website)
will indicate what the feedpoint impedance at the shack end might be for
the various bands of interest.
The KAT100 matching range does not usually favor extremely high
impedances, and because the 'delta LC' is fixed, the matching range will
be greater on higher bands than lower ones. To completely answer your
question, we would need to know the length and type of your feedline and
the band of operation - but I believe I have included enough information
that you can now figure it out for yourself.
73,
Don W3FPR
Brian Lloyd wrote:
Does anyone know if the KAT100 has enough range to match a radiator
that is close to (or is) an end-fed 1/2 wave? What I am thinking about
is feeding a dipole at twice its resonant frequency so that it is
effectively two end-fed 1/2 wave sections and then feeding with
ladder line. Now the ladder line will probably act as a transformer to
change the matching equation. (I know it won't change the SWR but the
magnitude of the resistance and reactance components will change.)
This also brings up a question I asked much earlier but didn't get a
good answer to. Will the Elecraft BL2 4:1 balun intended for 300/75
ohm operation still work properly when feeding the equivalent of two
end-fed half-wave antennas? If I recall these would represent about an
8000 ohm impedance. I was thinking of locating the balun very near the
tuner and using window line to the doublet. I am concerned about
losses and arcing (100W) in the balun in that specific instance.
--
73 de Brian, WB6RQN
Brian Lloyd - brian HYPHEN wb6rqn AT lloyd DOT com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.24.4/1478 - Release Date: 6/2/2008 7:12 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
