No, they haven't been eliminated, Mike. The bushings should be there. They hold the board vertical behind the rear panel.
Drop a note to [EMAIL PROTECTED] and they'll fix it for you. Ron AC7AC -----Original Message----- I finally started building my kit and have run across a small issue. I am to the stage where I need to install the KXV3 transverter board. The pictures show two bushings that appear to be soldered onto the board so that you can tighten down the board to the rear panel. The bushings appear to provide about a 1/2 inch of separation between the rear panel and the KXV3 board. My board does not have these two bushings. Has this been eliminated from the build? The kit was sent to me around the end of April. Everything else has gone together great. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
