Hmmm. I measure 0.2 to 0.4 ohms from shell of Foster jack to grounding lug to UHF connector on back, and from various other connector sleeves/shells to the grounding lug.
However, I have no continuity between line in and line out sleeves and chassis ground, which appears to be by design, looking at the schematic. Rear panel mic, speaker and phone commons are tied to chassis ground on the KI03 main board, but not the (xfmr coupled) line in and line out commons. Bob NW8L On Sun, Jun 8, 2008 at 6:33 PM, Joe Subich, W4TV <[EMAIL PROTECTED]> wrote: > > > Unfortunately, neither the front panel nor the KIO3 have good > shielding connections to the rest of the radio - at least not > with my factory assembled K3. I measure between 5.5 and 6.0 Ohms > from the shell/ring of the Foster jack to the grounding lug and RF > (antenna) connectors on the rear panel. I also measure between > 5.5 and 6.0 Ohms from the sleeve of the rear panel (3.2 mm) Mic > jack to the ground terminal and about 24 Ohms from the sleeve of > the Line in and Line Out jacks to the ground terminal. > > 73, > > ... Joe, W4TV _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
