Frank and All,
I'm not sure what radio you are using, but on my K3 I get better reports
using my headset with the IC element than I do with the other one that has
the HC4/HC5 combo. Also, with a little manipulation of the internal
equalizer, you can make the IC element sound very much like the HC4 I would
think. But if you still want to try changing it, it wouldn't be a hard
thing to do. Just swap out the elements. On the K3 you would then remove
the bias by menu change. On the K2 you would have to lift the jumper
providing bias to pin 1.
Dave W7AQK
----- Original Message -----
From: "Frank Lammel" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, June 10, 2008 1:21 AM
Subject: [Elecraft] Proset K2 Replace IC with HC-4 ?
Hi all,
I am thinking about replacing the IC Mic in the Proset K2 with a HC-4. My
questing: Can I do this without any aditional things? Just solder out the
IC and solder in the HC-4? Or isn't it that simple? Of course with no bias
then...
However if it is that simple, what do you guys think? Would you recommend
this or is it better to leave the IC with the Proset K2 at the K3?
73!
Frank, DD7ZT
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
