I spoke too early, the problem is back intermittently. The problem is *not* high SWR indication, nor actual high SWR, so there is definitely a problem here. It looks like if I try again and again I will eventually get it to stay on (3 or 4 attempts typical). BTW when the power drops, the SWR bargraph drops to 0 bars.
I am again suggesting this has something to do with the recent changes to CW/SSB keying modes. I have not made any changes to CONFIG in response to any of these changes. Is there anything in CONFIG that I ought to check? Knut - AB2TC ab2tc wrote: > > Thanks to everybody who responded. I am back on 2.02 and the problem did > not return. Interesting; I swear I wasn't dreaming it up. I was tuning on > the dummy load so it was not SWR or RF, but I suppose it could be that the > K3 was reading a high SWR due to some problem with the internal SWR meter. > I usually have my meter set to ALC and use my external tuner's SWR meter. > If it happens again, I will investigate this possibility. Are the symptoms > I described compatible with a shutdown due to high SWR (just 0.0W in the > display, 0W output and no other error indication)? > > Knut - AB2TC > > > Mike N8XPQ wrote: >> >> No problem here either. Make sure that your SWR isn't changing or is off >> in left field from the start. >> >> Mike N8XPQ >> K3 #248 >> V2.02 >> >> >> > > -- View this message in context: http://www.nabble.com/K3%3A-FW-2.02-TUNE-problem-tp17745776p17765446.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
