Joe:
Refer to the Manual, and run VCO MD as directed there.
That did it for me... last night, for that matter.
73,
Tom Hammond N0SS
At 12:16 06/12/2008, Joe Word wrote:
After upgrading to 2.02 firmware I get the error message "ERR PL1"
when I go to 12 meters in SSB mode. The message stays on the screen
for a few seconds.
Anybody else see this?
Joe N9VX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
