ab2tc wrote:
I don't think this is a problem with K3 at all. All you need to do for
split operation is to start by pressing A->B when on the DX' TX
frequency. Now both VFOs have the same frequency and modes.
Not here: VFO B comes to the same frequency as VFO A, but NOT the same
mode (that's with the latest firmware). A search through the archives
reveals this had been a problem once, but was said to have been fixed
several versions back.
Enable SPLIT. Now you can start hunting for (or guessing) the DX'
listen frequency, once you find it, press A/B and call the DX. The
important part is to establishing a starting point with the A->B button,
Agreed, that's how it should happen. The pre-configurable offset is a
minor refinement to save time (although it also has a different use for
repeater splits).
much like the AUTO SPLIT you were asking for (I have never seen AUTO
SPLIT but I haven't tried that many radios).
--
73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
