Dave and Glenn (ON4WIX), Thanks - the TECH MD worked. The errata sheet that came with my Owner's Manual referred to an update to the REF CAL procedure in a future firmware update and I assumed that it was included in the latest. So much for assuming :) I'll keep my eyes on the reflector...
73 and CU on the bands. Bud N7CW -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dave G4AON Sent: Monday, June 16, 2008 12:08 PM To: [email protected] Subject: [Elecraft] K3 - REF CAL Question Bud, this one crops up from time to time, unfortunately Elecraft haven't yet implemented the higher stability TCXO calibration routine... So you can't calibrate it better than 1ppm. The technical menu needs to be turned on in order to view the PA temp, etc. 73 Dave, G4AON K3/100 #80 ---------------- I don't seem to be able to get my K3 to go from REF CAL to REF xxC. Tapping the 1 just changes from A to B. I have the latest firmware and I can't find anywhere I'm supposed to tell the firmware that I have the 1 ppm oscillator. Can anyone tell me what I'm missing? <SNIP> 73, Bud N7CW _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
