Are you SURE the antenna is working fine with the other rigs? George
On Mon, Jun 16, 2008 at 6:44 PM, ni0c <[EMAIL PROTECTED]> wrote: > I've completed the initial build of K3 > s/n 1061 and am having trouble receiving > anything. The receiver perks up a lot > when I just connect the center pin of my > coax to the ANT1 jack. It goes dead > completely as soon as the shield makes > contact with the connector. > My antenna works fine on my other rigs. > > I have the KANT3 module in the K3 > (no antenna tuner). > > The ANT1 input reads a dead short > with an ohmmeter. > > I have completed the VCO cal, > filter settings and enabling, etc. as > outlined in the manual. > > Any help would be appreciated. > I'm suspecting the trouble is in the > KANT3 module. > > 73, > Chuck Guenther NI0C > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
