[EMAIL PROTECTED] wrote:
...
Problem:
Cannot get any transmit power out.
...
Receiver is OK and receives on all bands
No error messages displayed on either RX or TX
I can hear weak signal from K3 on other ham
transceiver.
Hi Jim,
You didn't say that you have run the TX gain setting procedure. If not,
do that first. If there is a problem with the LPA you'll see ERR TXG
message in the VFO B display area.
My K3 had a defective LPA module, which Elecraft quickly replaced once
we determined that power at the input to the module was OK, but no
output was being produced on any band.
Gus Hansen
KB0YH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
