Check the Elecraft web page for upgrades that either rig might be lacking in support of the KPA. Also make sure your Firmwares are up-to-date. I would recommend doing a reset on the older rig after install hardware and prior to configuring setup. You may want to check your filter configs and record any configs that will get wiped in a reset. Of course all power settings thru the KAT will need to be cal'd too.
Al WA6VNN, K3#31, K2# 4887 & 6281 ++++++++++++++++++++++++++++ In a message dated 6/20/2008 9:56:26 A.M. Pacific Daylight Time, [EMAIL PROTECTED] writes: I'd keep the K2/10 with the KAT2. That's a nice tuner and can't be used with the PA. The only other option in the qrp rig you don't have for the qro is the K60RX. Might be better to move that than to waste the KAT2. Dan / WG4S / K2 #2456 <snip> Here are the two radios: K2/10 S/N 02689 with KSB2, K160RX, K60XV, KNB2, KAF2, KAT2 k2/100 S/N 3523 with KSB2 ( I have KNB2, K160RX and KAF2 kits to install ) What I would like to do is pull the KPA100 out of the one radio and make what is currently the QRP radio a K2/100. </snip> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com **************Gas prices getting you down? Search AOL Autos for fuel-efficient used cars. (http://autos.aol.com/used?ncid=aolaut00050000000007) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
