Are you in PA NOR or in PAIO NOR? You need to be in PA NOR to enable high power.
Bob NW8L On Fri, Jun 20, 2008 at 9:01 PM, Bill Maddock <[EMAIL PROTECTED]> wrote: > I just installed the KPA3 - the fans work in the test mode - I let the > config in NOR instead of not installed. I am still only seeing 12 watts > out - running the 1.96 firmware that came with it. I set the PA temp > according to the sheet - I can not get xmit LP to HP for so reason - > any ideas - maybe I'm just tired? The fuse leads are hooked up. > > Question #2 I know that you have to configure the roofing filter for > each mode - Do they need to be configured on each mode on every band > or just one of the bands to cover for all bands? > > Anyone got any ideas? > > Thanks and 73, > > Bill N4ZI > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
