Thanks Bill. I'll give these a try. 73, Bob N6WG ----- Original Message ----- From: "Bill W4ZV" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Saturday, June 21, 2008 10:52 AM Subject: Re: [Elecraft] K3 #811 Locked Up
> > > > Robert Tellefsen wrote: > > > > Guess it's my turn to have a problem. > > Rig here is K3 #811. > > Options are KAT3, KXV3, KBPF3, 400 Hz 8 pole xfil. > > > > My problem is that at turn-on I have every icon on the LCD display on > > simultaneously, almost like an LCD display test. > > Rig doesn't respond to any commands. > > Tried connecting to the K3 Utility, and it says, > > "Cannot communicate with K3". I've checked both serial ports, > > so that doesn't "appear" to be the problem. > > I've tried recycling power several times with no luck. > > > > What can I do to break it out of this? > > > > Try rebooting the computer with the K3 off. Then power on the K3. If that > doesn't work, try EE INIT on page 55 of the manual. Here are a couple of > additional points I discovered when I did this once (submitted to Elecraft > but not sure it's in the current docs): > > ****************************************************** > 1. 4th bullet from bottom of p 55 "When EE INIT completes..." I found it > necessary to PWR OFF and ON my K3 to continue the process. > > 2. 3rd bullet from bottom "If you have a computer..." My K3 Utility had to > be closed and reopened to remove an error on the Config page (something like > "colon missing" at bottom of Utility Config window) which was preventing me > from checking Filter Configuration to see if Restore got all the settings > correct (...it did). > ****************************************************** > > I also hope you've recently done a Config Save...otherwise you may need to > go through all the Cal procedures in the manual. > > 73, Bill > > -- > View this message in context: http://www.nabble.com/K3--811-Locked-Up-tp18046875p18047105.html > Sent from the Elecraft mailing list archive at Nabble.com. > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
