> I didn't mention DXlab because I don't > think Dave AA6YQ has added any K3-specific code.
Yes, the K3 is specifically supported. Dave and I have been exchanging e-mail on adding filter support for the K3 (FWxxx; command). Unfortunately there are a few issues ... Dual PB filter is only available through the SWH command with no way for the control program to know its state, no way to select the 1st IF filter, and no way to set the center frequency. I don't know if it wouldn't be better to wait on documentation of the ! and @ commands. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Simon > Brown (HB9DRV) > Sent: Sunday, June 22, 2008 4:24 AM > To: [email protected] > Subject: Re: [Elecraft] 3rd Party K3 Compatibility Question > > > N4PY's software has K3 support. In fact any code written for > the K2 will > work with the K3, I didn't mention DXlab because I don't > think Dave AA6YQ > has added any K3-specific code. > > Simon Brown, HB9DRV > > -------------------------------------------------- > From: "Joe Subich, W4TV" <[EMAIL PROTECTED]> > > > > > All of the microHAM Interfaces plus microHAM Band Decoder > and microHAM > > Station Master also DXlab Suite (specifically CI-V > Commander the radio > > control application but also the entire suite > logger/digital ap/etc.). > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
