You can install the KPAIO3 interface from your KPA3 Option kit. It will replace the jumper block in any case. You can install it only, then finish up with your tests and calibrations before going back to finish the KPA3 installation.
Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of OE5CSP-Chris Sent: Friday, June 27, 2008 4:08 PM To: [email protected] Subject: [Elecraft] Power Amplifier Jumper Block I almost finished my K3 tonight, but now there´s a problem. The assembly manual on page 54 says, that the Power Amplifier Jumper Block is already installed.Unfortunately there is no jumper installed in my K3 and I can´t find it anywhere. I´d like to install the KPA 100 tomorrow, but I can´t go on without doing the tests and calibrations(page 57) Did I miss anything or is this jumper not required any more? vy73 Chris-OE5CSP,K3 #1073 -- View this message in context: http://www.nabble.com/Power-Amplifier-Jumper-Block-tp18165421p18165421.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
