W6TJK wrote: > > I reached the stage in building K3 where it requests that I enter the info > for the xtal. > > The provided sheet had columns of numbers, but no column headings ?? > The instructions (in manual) were very unclear on how to proceed. > > Do you have better (ie. clearer) procedure for this ? > > what sequence of which buttons, knobs, etc. > how/when is info (ie. numbers) to be entered > >
You can't at the moment. There is no support for this yet in the firmware. ----- Julian, G4ILO K3 s/n: 222 K2 s/n: 392 G4ILO's Shack: www.g4ilo.com KComm for K2/K3: www.g4ilo.com/kcomm.html -- View this message in context: http://www.nabble.com/KTCXZO----entering-table-info-tp18202242p18204121.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
