See Operator Manual Addendum on linking and unlinking the VFOs.
Jim K4JAF
----- Original Message -----
From: "Dave" <[EMAIL PROTECTED]>
To: "Elecraft" <[email protected]>
Sent: Thursday, July 03, 2008 7:39 AM
Subject: [Elecraft] Tuning VFO control
Hi-
Tuning VFO-A also tunes VFO-B. I want to change that. I want VFO-A to just
control VFO-A, and VFO-B just to control VFO-B.
Now, if VFO-B is set to a different frequency than VFO-A, the two will
retain their different frequencies and will track continuing that
separation by turning VFO-A.
VFO-B only tunes VFO-B.
I can tune VFO-B to a different frequency and then shift it into VFO-A
position as I should. Then VFO-A continues to tune both and retain that
new separation in frequency.
I don't have the sub receiver and no transverters.
I'm sure their is a simple solution, I just keep missing it.
73 de Dvae, K1OPQ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
