Bob,
You need a power supply that develops at least 14.1 volts and up to 14.3
volts to properly charge the battery through the K2 coaxial power jack.
It sounds like you were using a 13.8 volt supply.
73,
Don W3FPR
Bob G3YIQ wrote:
I've just installed the KBT2 option in K2 Nr. 5336. Everything checked out OK
and I charged the battery for 1 6 hours from a bench power supply. The power
supply showed some 200 mA or so being drawn initially but after overnight
charging this had fallen to a few tens of mA. When I switched the rig on the
battery only measured 11.5V on the K2's voltmeter. The rig worked on receive
but I just got a slight hum, no indication of any output and a low battery
warning when I put the rig into TUNE. I would be grateful for any
suggestions. 73 Bob G3YiQ
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
