In the manual errata, the following mentions setting alternative filter
"norm" settings. I think this has been mentioned previously, but mine
doesn't seem to work as the manual errata suggests it should. The
"-SAV-" appears but only for a split second, not allowing time to pick
an alternate... I am using firmware 2.13, but haven't tried using the
ALT filter settings previously.
From the manual errata:
In addition to the K3's standard "NORM" values, you can save two of your
own often-used filter setups in each
mode, and recall them using the NORM function. These are referred to as
ALT1 and ALT2. To save a filter
setup, hold NORM until you see "<- SAV ->" (3 seconds), then rotate the
knob left or right to save it as ALT1
or ALT2. (The arrows to the left and right of "SAV" are a reminder that
you can rotate the knob left or right go
get to the "ALTernate" filter memories.) To recall, hold NORM until you
see "<- NOR ->" (about 1/2 second),
then rotate the knob left or right to recall ALT1 or ALT2.
73 Dave
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
