I am waiting on my KRX3 (backordered since July '07) but decided to check my K3 for the value of R91.
My K3 s/n 559 had 100 ohms for R91. I removed the existing 0603 sized resistor and replaced it with an 0805 size 22 ohms that I had on-hand. (The method I usually employ for resistors and caps is to use two soldering irons, one in each hand. Observing through an Opti-visor, heat both ends of the component simultaeously, and gently lift it off the board.)The pads on the PC board are large enough to allow the used of the 0805 component. I had no difficulty performing this mod. I look forward to installing the KRX3 once it arrives. 73, Bruce N1RX _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
