Is the KXV3 installed? If so have you tried pulling it? Bob NW8L
On Sun, Jul 13, 2008 at 8:30 AM, Randy Downs <[EMAIL PROTECTED]> wrote: > I guess I spoke to soon. All went together very well and seemed to work fine. > After a good nights sleep I woke up and moved the radio off of my repair > bench on to my radio bench and hooked it up. All seemed ok until I went to 10 > meters. I started hearing static crashes like I was on 80 or 160. I unhooked > the antenna and they were still there. Very random. Up to an S7 sometimes. > All mode only on 10 and 12 meters. Yep I used a wrist strap and a mat. I > brought them home from work. I have a nice Speidel stainless wrist strap. > Probably don't make them anymore! USA made! Anyway K3 rf board prints sheet 2 > everybody. The noise goes away if I open W1 jumper by pulling the module. I > left the module out and jumped W1 and it comes back. If I pull W3 pa bypass, > (I believe this is the small pc board I pulled when I installed the 100w PA) > the noise is still there.I pulled the 100w pa and the lp board and it's still > there. Looks like it may be a problem around the t-r switch on the rf board. > The noise is totally random. Flexing, freezing or heating seems to do > nothing. It may be ok for 5 minutes and then do it for 5 minutes. I've > emailed support. Any others have any ideas? > Randy > K8RDD > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
