WinKey and the K3 can not share the same port. N1MM enforces the WinKey settings at 1200 bps (value set does not matter) DTR=ON RTS=OFF because the DTR=ON and RTS=OFF are required by the stand alone K1EL serial WinKey.
You must not have any port checked for CW EXCEPT the port being used by WinKey. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > [EMAIL PROTECTED] > Sent: Wednesday, July 16, 2008 11:54 AM > To: [email protected] > Subject: [Elecraft] K3 --> N1MM Logger > > > Hi all, > > I'm having trouble keying the K3 with N1MM Logger. I use > MicroHam CW Keyer. It works fine with AC Log, both rig > control and CW Keying. The rig control with N1MM Logger works > fine. But CW keying doesn't. I have attempted to configure CW > as follows: check the CW box, Com port 4800, N, 8, 2. DTR and > RTS to Always Off (thought that was the Elecraft preference), > and the Winkey box checked. > Sometimes this works, sometimes not. > > Every time I reenter N1MM, it has always been reset to DTR > Always On, RTS Alway Off, and Winkey unchecked. > > Would appreciate a note off line with anyone who has made it work. > > 73, > > John W9LHG > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
