Hi Ken (and Bill),
Quantizing the VFO in COARSE mode is on the list for a future firmware
revision. This will eliminate the offset you described.
73,
Wayne
N6KR
I have noticed what you describe below with all versions of firmware.
I have verified that it occurs both on transmit and receive. At the
most you could be 99Hz off of your displayed freq. If you were at say
14.200099 in the fine mode and then switched to coarse display of
142000 you would actually be transmitting and receiving on 14.200099.
The 99Hz will always be there even if you move the VFO. I find this
irritating but since I am aware of it I can work around it. I hope
that it will merit a future update
73, Ken N0QO
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
