Johnny, I will leave the detailed troubleshooting to those who have the KRX3, but I suggest for starters. 1) load the latest firmware - If you have older firmware may not contain all the KRX3 support required. 2) Check and recheck to be certain everything is plugged in correctly.
73, Don W3FPR Johnny Siu wrote: > Hello Group, > > Let me just re-written my emails as follows: > > After installation of the KRX3, I notice the following > errors: > > 1. In CONFIG: KRX3. I only get NOR but NOT NOR-ANTx; > 2. in CONFIG: VFO IND, I canNOT turn to 'yes' > 3. when calibrate the 2nd synthesier, I get 'busy' > first, then E00039 and ERR VC4 upon completion. > > Can any of you kindly advise where to start trouble > shooting. > > TNX > > Johnny Siu VR2XMC > K3#46 > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
