For Digital modes, MK2R+ uses audio from the Line Out ... audio
selection is controlled by the RECORDING/DIGITAL controls - not
the headphone switching matrix. Be sure you have selected the
correct (left channel only) audio from K3 in MK2R RECORDING/DIGITAL.
K3 Line OUT should be set close to NOR with the level about 20.
MK2R should NOT be set for WTY ... MMTTY should be configured
to use the USB Audio CODEC (check the WAVE IN ID in Router).
73,
... Joe Subich, W4TV
microHAM America
http://www.microHAM-USA.com
http://groups.yahoo.com/group/microHAM
[EMAIL PROTECTED]
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED] On Behalf Of Mike Kasrich
> Sent: Saturday, July 19, 2008 8:35 PM
> To: [EMAIL PROTECTED]; Elecraft
> Subject: [microHAM] MK2R+
>
>
> Guess Im just stupid but thats the way it goes. Ive been
> trying to get MMTTY to work with the mk2r+. I seem to get
> xmit ok but cant receive. The audio comes out the speaker
> instead going line out the back Im guessing. Ive changed
> just about everything that seems audio/speaker related to
> get the audio where it needs to be w/o luck.
>
> Any suggestions?
>
> Mike/aj9c
>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
