Hey All,
K3 #1264 is built, and I must say it was a sweet build! The only
problem was installing the front panel until I remembered about the 2D
screw hitting the corner of the board. If I would have turned the page
over and read ahead, I would have seen it there. I suffered a
calibration challenge on the 50w tx part. After a call to Scott and Dale
(great guys!) I discovered that my cable from the radio or my cheap
dummy load was bad. Replaced those and had to call back to report all
passed with flying colors!
I am just relaying the above to say 'Make sure your test gear is as
good as the radio you are testing!' The fit and finish of the parts is
top notch and even though there are a couple of errors in the manual
still, even a limited experience guy like myself can build this radio.
Awesome radio and awesome customer service! Thank you Elecraft! 73
In His service,
Jim Cundiff KB3GFC
K3 #1264
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
