I just finished installing the KXV3 option in my K3. Everything went
smoothly until I got to the step on page 10 where you plug the KXV3
board into J66. The instructions say the pins will just barely clear
the top of J66. Well, try as I might I couldn't get the pins to clear
the top of J66. So I clipped off the tips of the pins until they
cleared J66 and I could plug the KXV3 board into J66. Anyone else have
this problem? If so, Elecraft may want to add something to this effect
to the installation instructions.
Mike, ks7d
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
