I have my K3 on order, and plan to take all of the standard ESD precautions
when I build it. My question is about after it is built and in operation.
I just got through paying to have a new control board put in my Kenwood TS-2000
because it apparently had some ESD damage. I always disconnect my gear during
thunderstorms, etc., so I assume it came in as a result of having the audio
input and output and data lines connected to other equipment. I would hate to
have a repeat of that situation with the K3. Does anyone have any thoughts
about the K3 and static damage or any special precautions that should be taken?
Thanks for your help.
73,
Mike, WC0L
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
