Tom,
You should use the 31 bPS PSK-D setting as DATA MODE. If you want to use
AFSK anyway, set it to DATA-A.
If you want to generate AFSK-PSK31 with the Microham MKII, read
http://www.microham-usa.com/Downloads/MKII_RFI_Fix.pdf There is a problem
with the shield of the USB-cable.
73 's Steef PA2A
----- Original Message -----
From: "Tom Wylie" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, July 29, 2008 1:35 PM
Subject: [Elecraft] Help with PSK
I am trying (and failing miserably) to set up my K3 to work PSK31 mode.
I am using a Microham USB Microkeyer II and my normal Logger 32 software
which I have used for aged with my MP running very fb.
The outgoing tones from my K3 dont "sound right" and a near neighbour says
my signal is very bad
unreadable and very broad.
In the K3, I have the compression set to 0 the mike gain set to 0. I
am in Data mode and using DATA MD have PSK D showing - 31 bps.....
My K3 ALC meter is still showing almost full ALC (according to the meter)
with almost now poer output (turned right down).
I have the TX knob on my Microkeyer set at zero and within Logger
soundcard - psk window, have the output set right back, well below the
settings for the MP!
I am receiving PSK no problem at all. The radio is connected to my
computer via the serial port on the rear...
I can run RTTY FSK without any problem whatsoever.
I think i need a little guidance here...
Tom
GM4FDM
--
So I met the bloke who invented crosswords today. I can't remember his
name, it's P something T something R.
---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 080728-0, 28/07/2008
Tested on: 29/07/2008 12:35:55
avast! - copyright (c) 1988-2008 ALWIL Software.
http://www.avast.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
