Good evening Lyle: I honestly don't know where you're getting those levels from as I already reported to you back in April/08 that the levels at the I F output were pretty well non existent. There is just no tracking of levels at the I F out with what is fed into the antenna input of the receiver. I even used a 15 db amplifier from Jack Smith of Clifton Laboratories without any luck as there is simply no levels to play with there. I believe that Jack Smith also queried you about that without getting a proper reply as yet from you. I realize that nobody is perfect but why are we dogging a proper reply and/or fix for that? Fern with K3 #412
----- Original Message ----- From: "Lyle Johnson" <[EMAIL PROTECTED]> To: "Don Ehrlich" <[EMAIL PROTECTED]> Cc: "Elecraft Reflector" <elecraft@mailman.qth.net> Sent: Wednesday, July 30, 2008 9:18 PM Subject: Re: [Elecraft] K3 KXV3 IF Output Level? > The 2nd antenna input works as expected but my oscilloscope shows no > signal (<5 mV) coming from the IF Output on the KXV3. What IF signal > level should I be seeing? It will be about the same level as at the antenna, or perhaps less, depending on settings of PRE, ATT, etc. 73, Lyle KK7P _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.516 / Virus Database: 270.5.6/1574 - Release Date: 7/25/2008 4:27 PM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com