I would like to establish the "correct" setting for transmitting proper QRP SSB signals from my K2.
I have seen earlier discussions on the definition of QRP for SSB signals, where the majority seem to set it at 10W PEP (presumably close to 5W average power), while a few adhere strictly to the notion that no more than 5W should enter the antenna terminals at any time. At any rate, this brings me to the question: If I adjust the power level of my K2 to, say, 5W, using the power knob, will the rig then actually send out SSB at 5W PEP, 5W average, or something else? 73 - Kristinn, TF3KX -- View this message in context: http://n2.nabble.com/K2-power-setting-for-SSB-QRP--tp678796p678796.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
