After a smooth build I have ground to a halt at the low power filter calibration stage.
I get the "ERR TXF" error message. I have a 2.8 KHz filter in slot 3 and a 400 Hz filter in slot 4. When I try to transmit with a paddle I get dots (or dashes) and then the error message. I have gone thru the filter setup more times than I can count and nothing changes. The Width button cause the display to show which filter is being used as it goes up or down. The TX led flashes. FL1, FL2 and FL5 are all set to off. FL3 has FL BW = 2.8 FL4 has FL BW = .4 FL1, 2 and 5 have the BW set to 0. All the filters have the FRQ and GN set to 0. I am going to call Elecraft but being Saturday I am not sure I'll reach anyone so I have turned to the reflector. I tried searching archives but only found "check the filter setup" answer. Nothing specific enough to make me see what I have done wrong. I am going to take a nap now after staying up all nite trying to figure this one out!!!!! Jack, AE6GC, KX1 1403, K3 1433. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
