According to the K3 manual, by tapping DISP, you can rotate the VFO B knob through time, date, supply voltage, current drain, KPA3 heatsink temperature, and front panel compartment temperature. When tap DISP, I get time, date, supply voltage, and current drain only - I do not have a temperature selection. In its place is "0.00". I did do both temperature sensor calibration procedures. What am I doing wrong?
Larry WA9MAG _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
