For special equipment, you need a DVM, dummy load, and ESD
Mat/wrist strap (e.g Radio Shack 276-2370).
The kit is not hard to build. It is mostly just a mechanical
assembly process and the instructions are good. However, you
are assuming several risks in building a kit.
-One of the subassemblies may be defective (undetectable in
subassembly factory testing).
-Something may be missing in the kit, causing a delay.
-You may make an assembly error or cause an ESD problem.
In those cases, there will be much headscratching, gnashing
of teeth, disassembly/reassembly and you may have to ship
the radio back for repair. Shipping will cost about fifty
bucks, with insurance. On the good side, excellent advice
from the Elecraft tech support team will be rapidly provided
if you get into a problem.
If I were to order another one (that would be #3 for me), I
would order it factory-built. There is nothing like a final
assembly test to prove that everything is working right.
Dave Hachadorian, K6LL
Big Bear Lake, CA
----- Original Message -----
From: "Scott McDowell" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Sunday, August 10, 2008 12:43 PM
Subject: [Elecraft] K3 kit
Hello
I should be getting my K3/10 kit in a couple of months and
woud like to know
what I will need in the way of test equipment to get it
aligned and tuned
up?
A digital volt meter is about the extent of my test
equipment.
Besides that I'm a numb brained old man that has to ask
the xyl what my name
is every morning! It really is almost that bad, should I
even be considering
building
a K3?
Thanks
Scott N5SM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
