Steve,
If you have the TX EQ set for a corresponding rolloff, then the answer
is yes. Currently there is only one TX EQ that applies to all modes.
Someday (soon) you can have separate TX EQ settings, but right now, TX
EQ is TX EQ no matter what.
73,
Don W3FPR
Steve Jackson wrote:
My K3 setup is configured to put out about 30W on PSK31, with my sound card
dedicated to APSK/AFSK modes and its output locked in place to make that power
level at 1250 Hz. My TX IMD is excellent.
However ... if I select a PSK31 spot where the resultant audio frequency is
below, say, 800 Hz, my TX output power drops off precipitously as the audio
frequency goes down.
I am in DATA A mode. It's as if the audio to the transmitter in this mode is
sent through my SSB TX EQ settings.
That isn't how it works ... is it?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
