On Fri, 15 Aug 2008 19:06:39 -0700 (PDT), N8XPQ <[EMAIL PROTECTED]> wrote:
> >I was thinking that it would be nice to have a menu selection that would >allow you to select a power output by mode. This would enable those that use >an amp to easily switch modes Ex. SSB requiring slightly higher drive power >and CW requiring a lower drive level. We already have a menu option that >allows one to select power output by band. What does everyone think of this? > >Mike N8XPQ Why do you need to set the drive higher on SSB than on CW? Are you trying to adjust for the same average watt meter reading on SSB as on CW? If you are that will make your SSB output greater than your CW output and if you are setting the drive to show 1500w on average in both modes you will be transmitting at an illegal power on SSB. Leave them both the same and you will have the same PEAK output in both modes, which is what is the legal setting on SSB and CW. To prove this, if you have a monitor scope, observe the PEAK output on both modes and you will see that the CW PEAK and the SSB PEAK are the same when you set the drive with CW, unless your mic gain is too low. If the mic gain is too low, don't adjust the drive, adjust the mic gain until the peak output on the scope is the same for SSB as it is on CW. Tom, N5GE - SWOT 3537 - Grid EM12jq "Those who would give up Essential Liberty to purchase a little Temporary Safety deserve neither Liberty nor Safety" An excerpt from a letter written in 1755 from the Assembly to the Governor of Pennsylvania. Support the entire Constitution, not just the parts you like. http://www.n5ge.com http://www.eQSL.cc/Member.cfm?N5GE _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
