Roger wrote:
Group,
What haven't I done? My KRX3 is deaf!
Here is the story. After installing the KRX3 and checking to see if all pins and cables were properly seated, I went thru the CONFIG steps and downloaded the latest firmware, FPF and DSP1 & DSP2. Loading was successful. I activated my 2 SUB Filers (2.8 kHz & 400 Hz. But no audio!.
What have I missed? Where should I look next? I did remove the hard wired W4 jumper.
Did you enable the KRX3 in the CONFIG menu? You didn't mention this step
in your problem description.
Gus Hansen
KB0YH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
