Bill, Just a word of Caution - though the K3 can take a standard Serial cable - I've read that the K2 CANNOT. If you plug a standard serial cable into a K2 you will Blow the I/O board. I mention that because when you mentioned your K2 was at the lake cabin, it sounded like you thought the cables were interchangeable. The K3 may work with the special K2 cable - I don't know about that. But again, It's been posted that plugging an "off the shelf" serial cable into a K2 (turned on of course) will destroy the I/O board. Paul
NZ0T wrote: > > In anticipation of my K3 arriving next week I'm tying to find the RS232 > interface cable. I'm going to be out of town a lot and pressed for > shopping time so I hope nobody minds my asking a dumb question. Where can > I get the needed cable - Best Buy, Radio Shack, Wal-Mart? My K2 will now > be at the lake cabin so that cable goes with it. > > 73, > > Bill NZ0T > -- View this message in context: http://n2.nabble.com/RS232-cable-source-tp729878p730040.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
