Hank,
It is 'automatic' *after* you set up the K1 correctly.
Follow the instructions on the manual - first align the BFO so the
center of the FL3 passband is at your preferred CW pitch. Then move the
switch on the bottom of the RF Board and adjust the transmit offset
equal to the same pitch.
After that is done, tune your desired signal to your preferred CW pitch
tone, then the transmit signal will be correct (and the dial will read
the transmitted carrier frequency).
73,
Don W3FPR
Hank/KEoCU wrote:
K1 question. Is the passband (or center) frequency of the xtal filter
automatically the same as the sidetone pitch? If it is, than zerobeating a
station at any selected sidetone pitch should automatically center the cw
note in the filter (?). If not, what do you do? I guess I'm a little unsure
how to make sure I transmit and receive on the correct frequency with
respect to the narrow xtal filter passband. Please enlighten me! Thank you.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
