For long horizontal lines near to the ground (<3ft, 1m, say) I've read that
some folks rotate the line between supports, supposedly to maintain balance;
what do you think about that?
David
G3UNA
----- Original Message -----
From: "list1" <[EMAIL PROTECTED]>
To: "Elecraft Discussion List" <[email protected]>
Sent: Monday, August 18, 2008 4:29 PM
Subject: [Elecraft] RE:balanced tuner
Hi David and all,
I have done a lot of EZNEC dipole simulations and have come to the
conclusion that the loss in 100 feet of coax off of resonance is about 12
dB
per 100'. Whether you use RG-8x or LMR400 doesn't make too much dfference
concerning losses off of resonance where your SWR with 50 ohm transmission
line can be greater than 200:1.
<http://www.pituch.net/Steve%27s%20Page/Radio/Antenna4/Antenna4.htm>
Because of this if I use 450 Ohm ladder line to a 1:1 baun, I try to keep
the length of coax going into the house less than 15 feet. For your 50
feet
of coax run you should never have a loss greater than about 1 S unit (6
dB).
When I went to 100 percent ladder line including inside the residence,
when
I built my balanced tuner, I used two 1/4-20 stainless steel bolts to feed
the signal through the exterior wood wall. I have "U" solder lugs on the
two
wires at the end of the 450 Ohm line, and I use two wing nuts to connect
the
ladder line to the house connection. When I am finished operating I go
outside at spend 5 seconds loosening the wing nuts and the ladder line is
no
longer connected to the residence. If I wanted further protction, I guess
I
could drive a ground rod 15 feet away from the residence and wing nut the
end of the ladder line to it when I am not operating.
I don't believe you can keep your antenna connected to your equipment and
ever be completely protected from lightning strikes (and that includes
coax). The air gaps don't work. For coax the gas surge traps may work to
a
degree, but I would much rather disconnect the transmission line than
depend
on one of these devices.
If you want so-called protection for 450 Ohm line why not use 2 Alpha
Delta
coax surge traps - one for each wire of the 450 Ohm line?
The thing about keeping the 450 Ohm line away from metal is overdone a
bit.
I find keeping it away from metal about 2 or 3 inches is fine.
Regards,
Steve, W2MY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
