Ordered KRX3 in June 2007. Rcvd K3 s/n 453 Feb 08. Rcvd KRX3 kit June 19. Completed KRX3 assy yesterday June 20.
Congrats to Elecraft for an excellent assembly manual. I only wish my fingers were smaller to handle the 4-40 hardware in tight places but, it got done. I had one scare when I fired it up after doing the startup routine. I enabled sub rx but got error mesage attempting VCO CAL in sub mode. I discovered I needed to update DSP2 firmware to V1.88 first. After I did that, the VCO CAL in sub and filter setup went smooth. Thanks again Elecraft Jim K7EG _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
